With its intense pine scent, Allpine Light is a biodegradable cleaner that will leave your bike clean and shiny. Its formula is very effective against dirt and does not require rinsing, making it ideal also for e-bikes.

• Rapidly biodegradable, pine scented and extremely effective against dirt
• Ideal for e-bikes, it can be used without rinsing with water in case of slight dirt, drying it with a cloth
• In presence of mud or on a very dirty bicycle, spray the product abundantly and leave it to act for a few minutes before rinsing with water
• It doesnt contain silicones but leaves the surface shiny, with an anti-water and dirt-repellent effect
• It doesnt remove lubricant from the chain
• Harmless to chrome, painted parts and carbon
• It doesnt require special disposal precautions (if in doubt, refer to the legislation in force)

Characteristics:

Biodegradable and with a pine scent

Allpine Light is harmless to the environment but very effective against dirt. After using it, you can get on a clean bicycle with a nice pine scent: a good way to start an epic ride.

Ideal for e-bikes, no need to rinse

There are times when you are in a hurry and a quick cleaning is sufficient, or especially for e-bikes – you want to limit the use of water close to electrical contacts. For these situations of moderate dirt, Allpine Light and a rag are enough to clean the bike, without the need to rinse with water.

Use without rinsing:

1. Spray Allpine Light on a clean rag and wipe the entire frame.
2. After cleaning, the surface will be shiny, with an anti-water and antistatic effect.

As it does not contain silicone, it avoids that annoying sticky effect which is a real dust magnet. The surface thus treated also facilitates the flow of water.

IMPORTANT: Allpine Light does not remove the lubricant from the chain, so it is not necessary to relubricate it after such a cleaning.

When the going gets tough, it doesn’t hold back

If the bike is very dirty and / or muddy, you have to perform a serious cleaning.

Use with rinsing:

1. Generously spray Allpine Light all over the bike.
2. Wait a few minutes to let the product act.
3. Rinse with plenty of water. A sponge or brush is recommended for an optimal result.
4. Dry with a clean cloth. If needed, use more Allpine Light – without rinsing – to remove any streaks or traces of dirt.
5. Lubricate the bicycle (chain, suspension, moving parts) after such a thorough cleaning.

Run out, just grab a recharge.